gas blow Torch

1.Gas blow lamp Working gas:G.F.L.
2.Gas blow lamp Wording pressures:DIRECT
3.Gas blow lamp IDEAL GAS 190g
4.Gas blow lamp787
1.Gas blow lamp Working gas:G.F.L.
2.Gas blow lamp Wording pressures:DIRECT
3.Gas blow lamp IDEAL GAS 190g
4.Gas blow lamp787
INSTRUCTIONS
FOR INSTALLATION
IDEAL GAS soldering irons have been studied and produced to be used only under the following conditions:
Working gas: G.F.L.
Wording pressures: DIRECT
Types of reloaded cartridge: IDEAL GAS 190g.
Insert of cartridge
Open the container of the cartridge keeping one hand on the blowpipe handgrip and the other on the base of the container and turn both parts towards the left.
Once the container is open provide to introduce the gas cartridge madding sure that the conical part rests on the perforator piece of the blowpipe which is located below the opening gas cock.
Tighten (screw) the container of the cartridge towards the right.
IMPORTANT-NEVER OPEN THE CONTAINER OF THE CARTRIDGE BEFORE ITS DISEHARGE AS OTHERWISE THE CARTRIDGE WOULD LOSE ALL ITS CONTENTS OF GAS

INSTRUCTION FOR USE
On: 1.open the opening gas cock of the blowpipe.
2. Bring the flame (wax match. lighter) near to the nozzle of the blowpipe. For model LASER 2PIEZO-LASER2 JUNIOR IEZO:Push the push-button of the electric piezo situated on the soldering iron handle.
3. Regulate the power of the blowpipe by acting on the opening gas cock..
Off: 1.Close the opening gas cock.
MAINTENANCE AND SAFETY
The blowpipe must be used in airy rooms.
The seal of the joints must be periodically checked especially in case of change of the blowpipe .For said purpose wet the joint with water and soap and check that there are no bubbles
IMPORTANT-THE CARTRIDGES HAVE TO BE DEPT AWAY FROM FIRE EVEN WHEN THEY ARE DISCHARGED
TUV 021 180